Drain Jetting Islington
Drain jetting in Islington blasts water through the pipe at high pressure to strip grease, silt and root growth from clay sewers and newer PVC alike. It suits drains that a plunger or eel has not fixed for long. The price is set before the hose goes in; book through your plumber in Islington.
Jetting is one of the methods grouped under blocked drains.
Licensed plumbers and gas fitters · NSW Lic. 359278C
Last updated September 2026
What Builds Up Inside These Pipes?
The joints on old earthenware sit rough and slightly offset, and each one catches something:
- Kitchen fat that cools and hardens on the pipe wall
- Silt washed into cracked sections from the damp ground around them
- Fine root hairs growing through the gaps
- Wipes and paper snagged on a lip and building into a plug
A plunger pushes that material a little further along. The jet scours it off the wall and carries it out to the sewer main.
How Do You Know Jetting Is Needed?
- A drain that slows again a few weeks after a hand clear
- Gurgles from a floor waste when the washing machine empties
- Water lifting at the yard gully after showers
- A sour smell near an inspection opening
The Jetting Process, Step by Step
- 01
Ring or send the form
Call (02) 4063 1232 or use the form to explain the fault. We ask enough to bring the right equipment the first time.
- 02
A fixed price first
A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.
- 03
Nozzle, pressure, flush
A nozzle chosen for the pipe goes in, the pressure rises in stages, and the loosened material washes down to the main.
- 04
Covered for a year
Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.
A camera run afterwards shows the pipe wall clean. A cracked joint on the footage leads to pipe relining instead of another clear.
What Does Jetting Cost?
We provide up-front, honest quotes that will always match the final price, should you decide to go ahead.
- Distance to the plug A blockage a metre past the gully is reached in minutes; one near the street takes more hose and time.
- The pipe material Clay gets a staged, gentler clean, and PVC in a new build does not need the same care.
- The way in A narrow side passage or a low subfloor slows the setup.
Flat Ground, Old Pipe
Almost no fall
Clay laid in short pieces
Figs along the grid
Tight blocks
What Customers Say
We talked through the options of our blocked kitchen sink drain (not just an s bend problem) and came to the perfect long term solution at a reasonable price.
When We're Not the Right Call
If the camera shows a section that has caved in, water pressure will not rebuild it, and the fix becomes a reline or a dig. A blockage out in the Hunter Water main is theirs to clear, and their faults team takes that report.
Jetting Questions From Islington Homes
Is jetting safe for the old clay pipes in Islington?
Yes, when the pressure suits the pipe. Earthenware gets a softer nozzle and a gradual build-up, PVC in the newer townhouses can take full pressure, and a camera run at the end confirms the pipe came through intact.
Does jetting get rid of roots for good?
Jetting slices roots off at the joint, but the crack they came through stays open. If the camera shows damaged collars, sealing them with a reline is what stops the next crop.
Are chemicals added to the water?
No. The jetter uses plain water. On this flat grid everything flushed ends up heading toward the creek, so keeping drain cleaners out of the line matters.
How is jetting priced here?
Three things set it: how far down the line the blockage sits, whether the pipe is clay or PVC, and how easily the machine reaches an access point. You get that price on site, before any work.
Need a plumber? Call or send the form
Call (02) 4063 1232 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.
Request a callback
Leave a name and number and a plumber will ring you back.