Skip to content

Gas Fitter Islington

Islington Plumbing Co is the licensed gas fitter for Islington homes and shops, fitting new appliances, tracing leaks and replacing old steel gas pipe. Each job is pressure tested and priced before work starts, and Islington Plumbing Co answers urgent gas calls day and night.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Plumber working on a gas oven connection
Freestanding gas cooker connected in a kitchen

What Work Does a Gas Fitter Do?

  • Connecting cooktops, ovens, space heaters and outdoor BBQ points
  • Gas storage and continuous-flow hot water connections
  • New gas runs, extensions and moving an appliance to a new spot
  • Leak tracing, pressure tests and repairs on existing pipe
  • Capping lines and bayonet points that are no longer used

Islington Gas Fitting Services

Gas Appliance Installation

Gas Leak Detection

Plumber beside a newly installed continuous-flow gas hot water unit

Old Gas Pipe in Old Cottages

Pipe older than the appliances

This was among the earliest Newcastle suburbs connected to gas, and some cottages still carry the original steel pipe inside their walls.

Hardened jointing compound

The sealing compound on those old joints dries and cracks with age, so a joint that held for decades can start to leak once it is disturbed during an appliance swap.

Hidden in cavities

Inside a double-brick or weatherboard wall, a failing joint gives little sign until someone smells gas, which is why testing comes before any new connection.

Newer builds start clean

Apartments and townhouses rising on the Throsby Creek corridor are built with modern gas pipe, so connecting an appliance there is closer to a straight fit.

When a Gas Smell Means Right Now

A smell of gas inside is not a booking to make for tomorrow. Get everyone out of the house, leave light switches, the doorbell and appliances untouched, and phone the gas network's emergency line from the footpath. Once their crew has made the supply safe, the leak on the house side can be found and repaired, and the steps for that are set out on the gas leak page.

Gas fitter at work on a kitchen oven

Gas Jobs, Step by Step

  1. 01

    Ring or send the form

    Call (02) 4063 1232 or use the form to explain the fault. We ask enough to bring the right equipment the first time.

  2. 02

    A fixed price first

    A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.

  3. 03

    Test first, then fit or fix

    The supply pipe is pressure tested, the appliance is connected or the leak repaired, and a detector checks every joint.

  4. 04

    Covered for a year

    Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

What Shapes the Price of Gas Work?

  • What is being connected A single heater point is a smaller job than an oven and cooktop on a new run.
  • The test result Pipe that fails adds a renewal to the day, shown as its own item.
  • Where the pipe runs Wall cavities and low subfloors in the old cottages are slower to work in than open framing.
  • Moving or extending a line Shifting a cooktop to the other side of a kitchen, or running gas out to a deck, means new pipe measured and priced by the metre of run.

What Customers Say

We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested
Lee

Where a Gas Job Isn't Ours

Not the right call: the gas meter, and everything between it and the street main, is the network's responsibility, and a gas appliance with a failed electronic control board may need the manufacturer's service agent.

Gas Questions From Islington Homes

Do you renew old steel gas pipe in Islington cottages?

Yes. When a section fails its pressure test, it is cut out and replaced with modern pipe, then tested again before any appliance is reconnected. That pipe work appears as a separate line in the quote.

Can a gas cooktop go into a pre-1940 cottage?

Yes, once the line feeding it holds pressure. Some cottages still carry their original steel runs, so the test comes first and a failed section is renewed before the cooktop is connected.

Do you handle gas work in Islington rentals?

Yes. Landlords and agents book gas appliance swaps and leak repairs the same way as owners, and the tenant is messaged before the visit. The old pipe in a rental gets the same pressure test before anything new is connected.

Can old bayonet points be removed?

Yes. Redundant bayonet fittings from earlier gas heaters can be capped off properly, or renewed if you want to connect a modern heater there.

Need a plumber? Call or send the form

Call (02) 4063 1232 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 1232

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 1232 Get a quote